Placement: Set the water dispenser on a stable, flat surface near an electrical outlet.
Water Bottle Installation: Avoid installing the bottle with the seal intact and do not use excessive force. Remove the bottle's seal before placing it securely onto the dispenser. 
Tap Verification: Ensure water flows from ALL taps especially the HOT TAP before connecting the dispenser to the power source.
Powering On: Connect the dispenser to a power source and switch it on using the COLD & HOT controls located at the back.
Dispensing Water: Use the hot, cold or normal taps by pressing or turning the knobs or buttons as needed.
Cooling Period: After setup, wait 4-7 minutes for the water to cool. 
Turn off the dispenser when the water bottle is empty.